Is your car affected?
Check by VIN to confirm the
exact model and see every recall for it.
Recalls are issued for a make, model and model year. Whether the repair has already been done on one specific car is known only to its manufacturer and dealers. Check your vehicle's official status at nhtsa.gov/recalls or with a dealer.
US recalls (7)
Electrical system
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2010 Lexus HS 250h Hybrid vehicles. A component within the hybrid transaxle assembly may short circuit and result in a reduction or a complete loss of available power for moving the vehicle.
Risk and remedy
Risk: A complete loss of motive power can increase the risk of a crash.
Remedy: Lexus will notify owners, and dealers will replace the hybrid vehicle transaxle assembly, free of charge. The recall began on December 1, 2017. Owners may contact 1-800-255-3987. Toyota's number for this recall is HLE.
Suspension: rear
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2006-2011 Toyota RAV4 vehicles manufactured October 31, 2005, to September 7, 2010, and 2010 Lexus HS250h vehicles manufactured July 6, 2009, to August 26, 2010. The affected vehicles have rear suspension arms (rear tie rods) with adjusting lock nuts that may have been improperly tightened after servicing. As a result of being loose, the arm may have thread damage and may rust, possibly leading to the failure of the arm and an abrupt change in the vehicle's alignment.
Risk and remedy
Risk: Failure of the rear tie rod could cause a loss of vehicle control, increasing the risk of a crash.
Remedy: Toyota will notify owners and dealers will replace both rear suspension arms and encapsulate the locknuts, free of charge. The recall began on September 30, 2016. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's numbers for this recall are G0V for Toyota vehicles and GLK for Lexus vehicles. Note: This recall supersedes recall 13V-383, in which some vehicles were only inspected, sealed, and did not have both arms replaced. The affected vehicles were previously recalled under 13V-383, but did not have both rear suspension arms replaced at that time. Those vehicles need to have both arms replaced as part of this recall remedy.
Suspension: rear
Toyota is recalling certain model year 2006 through 2011 RAV4 and 2010 Lexus HS250h passenger vehicles manufactured from October 2005 through September 2010. If the nuts for adjusting the rear wheel alignment are improperly tightened during service, the rear suspension arm (rear tie rod) may develop unwanted movement and rust leading to thread damage and eventual failure. Failure of the rear tie rod will cause an abrupt change in the vehicle's alignment.
Risk and remedy
Risk: Failure of the rear tie rod could cause a loss of vehicle control, increasing the risk of a crash.
Remedy: Toyota will notify owners, and dealers will inspect the tie rods and replace any that have rust or corrosion on the alignment adjustment threads. All of the rear tie rods will then be encased in an epoxy to prevent future environmental damage. Due to limitations in parts, the recall remedy will be launched in phases from September 2013 through mid-April 2014. All owners will receive notification of the recall, with most receiving second notifications when parts are available in their area. IMPORTANT: This recall supersedes Toyota and Lexus recall 12V-373. All vehicles that have been inspected and remedied under the previous recall need to be re-inspected and have the appropriate remedy applied.
Service brakes
Toyota is recalling certain model year 2010 Prius vehicles manufactured March 31, 2009, through October 9, 2009; and model year 2010 Lexus HS250h vehicles manufactured June 19, 2009, through October 9, 2009. Nitrogen gas from a component of the brake booster pump assembly could leak into the brake fluid.
Risk and remedy
Risk: As nitrogen is released into the brake fluid, the brake pedal may have reduced hydraulic pressure. Under certain circumstances, this condition could affect stopping distance and increase the risk of a crash.
Remedy: Toyota will notify owners, and dealers will replace the affected brake booster pump assemblies. The recall began on August 7, 2013. Owners may contact Toyota at 1-800-331-4331.
Suspension: rear
Toyota is recalling certain model year 2006 through 2011 RAV4 and 2010 Lexus HS250h passenger vehicles manufactured from October 2005 through September 2010. If the nuts for adjusting the rear wheel alignment are improperly tightened during service, the rear suspension arm (rear tie rod) may develop unwanted movement and rust, leading to thread damage and eventual failure. Failure of the rear tie rod will cause an abrupt change in the vehicle's alignment.
Risk and remedy
Risk: Failure of the rear tie rod could cause a loss of vehicle control, increasing the risk of a crash.
Remedy: Toyota will notify owners, and dealers will inspect the rear tie-rod nut for looseness and replace any suspect tie-rod found loose. Dealers will also affix instructions in multiple places to prevent improper servicing in the future. The recall began on November 30, 2012. Owners may contact Toyota at 1-800-331-4331 or Lexus at 1-800-255-3987.
Fuel system, gasoline: storage
TOYOTA IS RECALLING CERTAIN MODEL YEAR 2010 HS250h LEXUS VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY." WHEN THE VEHICLE WAS ROTATED FOLLOWING A CRASH TEST AS REQUIRED, THE AMOUNT OF FUEL LEAKAGE EXCEEDED THE ALLOWABLE LIMITS.
Risk and remedy
Risk: FUEL LEAKAGE, IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN A FIRE.
Remedy: TOYOTA WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE AFFECTED VEHICLES BY INSTALLING A NEWLY DESIGNED PROTECTOR COMPONENT FOR THE FUEL FILLER INLET PIPE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 9, 2010. OWNERS MAY CONTACT LEXUS AT 1-800-255-3987.
Service brakes, air: antilock, control unit/module
TOYOTA IS RECALLING CERTAIN MODEL YEAR 2010 TOYOTA PRIUS AND LEXUS HS250H PASSENGER VEHICLES. CUSTOMERS HAVE EXPERIENCED INCONSISTENT BRAKE FEEL AFTER ABS ACTUATION DURING SLOW AND STEADY APPLICATION OF THE BRAKES ON ROUGH OR SLICK ROAD SURFACES. STOPPING DISTANCES MAY BE INCREASED COMPARED WITH A CUSTOMER'S EXPECTATION FOR A GIVEN PEDAL FORCE.
Risk and remedy
Risk: VEHICLE STOPPING DISTANCES MAY INCREASE RELATIVE TO A CUSTOMER'S EXPECTATION INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL REWRITE THE PROGRAMMING OF THE ABS CONTROL UNIT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 3, 2010, AND IS EXPECTED TO BE COMPLETED IN LATE MARCH 2010. OWNERS MAY CONTACT TOYOTA AT 1-800-331-4331 AND LEXUS AT 1-800-255-3987.
Canadian recalls (8)
Show 8 Canadian recalls
Electrical
2021-11-24 · campaign 2021-723
Issue:
This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships.
On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt.
Note: This recall only affects the following block heater/cord part numbers:
C014003034 PK5A408J09 PU14000904
C014003151 PK5A408J13 PU14000905
C014000885 PK5A489J11 PU14000907
C014000888 PK5A489J22 PU14000909
C014000907 PK5A410H00 PU14000911
C014100904 PU14000900 PU14000913
C014100907 PU14000901 PU14003571
C014100911 PU14000902 PK5A489J14
PK5A408J05 PU14000903
Safety Risk:
Engine block heater wiring that overheats or melts could create the risk of a fire.
Corrective Actions:
Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.
Powertrain
2017-10-04 · campaign 2017-478
On certain vehicles, the holding plate of the hybrid transaxle assembly may have been crimped improperly during assembly. This could result in the plate to wear, potentially causing irregular movement around the motor shaft, which could allow the plate to contact the electric motor coil and lead to a short circuit. This would illuminate warning lights and warning messages in the instrument cluster, and cause the vehicle to enter a fail-safe mode resulting in reduced motive power. In some cases, the hybrid system could shut down, resulting in loss of motive power while the vehicle is in motion, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the hybrid transaxle assembly with a new one.
Suspension
2016-08-11 · campaign 2016-398
On certain vehicles, the rear wheel suspension link arms could separate. This could result in loss of vehicle control and cause a crash resulting in injury and/or damage to property. Correction: Dealers will replace both suspension link arms and encase them in epoxy to prevent future improper servicing. Note: This recall supersedes recall 2013327. As part of the previous recall, dealers were to inspect the suspension arms for corrosion, replace them depending on their condition, and encase them in epoxy. Only vehicles which did not receive replacement of both suspension arms through the previous recall will need to be repaired under this campaign.
Suspension
2013-09-25 · campaign 2013-327
On some vehicles, if the rear wheel alignment toe adjustment locking nuts are improperly tightened when an alignment is performed in the field, backlash may develop in the threaded portion of the suspension arm (shaft and turnbuckle), followed by the formation of rust. If this occurs, threads may wear, causing the arm to separate which could result in loss of vehicle control. Correction: Dealers will inspect the suspension arm threads for corrosion. If corrosion is found, the arm(s) will be replaced. If no corrosion is found, an epoxy sealer will be applied to the suspension arm to inhibit corrosion. Note: This recall supersedes recall 2012253. Vehicles that were repaired under the previous campaign will also need to be repaired under this campaign.
Brakes
2013-06-05 · campaign 2013-193
On certain vehicles, a fatigue crack could develop in the brake pressure accumulator. If this occurs, nitrogen gas could leak into the brake fluid and gradually cause the brake pedal stroke to become longer, resulting in decreased hydraulic pressure. This condition could result in longer stopping distances, increasing the risk of a crash causing property damage and/or injury. Correction: dealers will inspect the brake booster pump and, if necessary, replace it with an improved unit.
Suspension
2012-08-01 · campaign 2012-253
This recall was replaced by Transport Canada recall no. 2013-327.
On some vehicles, if the rear wheel alignment toe adjustment locking nuts are improperly tightened when an alignment is performed in the field, backlash may develop in the threaded portion of the suspension arm (shaft and turnbuckle), followed by the formation of rust. If this occurs, threads may wear, causing the arm to separate which could result in loss of vehicle control. Correction: Dealers will inspect the arms and verify the tightening torque of the lock nuts, or replace the arms, as necessary.
Fuel system
2010-06-25 · campaign 2010-210
Certain vehicles may not meet the requirements of the Canada Motor Vehicle Safety Standard (CMVSS) 301 - Fuel System Integrity. After a rear impact crash test, during a Federal compliance testing program, the post crash fuel spillage exceeded the limit specified by the Standard. Correction: Dealers will install a new protector component for the fuel filler inlet pipe.
Brakes
2010-02-09 · campaign 2010-037
On certain vehicles, an inconsistent brake feeling may be perceived after ABS actuation during slow and steady application of the brakes on rough or slick road surfaces and stopping distances may be increased compared to expectation for a given pedal force. Increased brake distance in a case of emergency may result in a crash causing property damage or personal injury. Dealers will rewrite the programming of the ABS control Unit.
Owner complaints (70)
Owners filed 70 complaints with NHTSA about the 2010 Lexus HS (5 crashes, 4 injuries reported).
| Most-reported problem | Complaints | |
|---|
| Service brakes | 20 | |
| Service brakes, hydraulic | 16 | |
| Service brakes, electric | 6 | |
| Suspension | 6 | |
| Electrical system | 5 | |
| Vehicle speed control | 4 | |
| Unknown or other | 3 | |
| Power train | 3 | |
Crash test ratings
NHTSA 5-Star Safety Ratings for the 2010 Lexus HS.
| Version | Overall | Frontal | Side | Rollover |
|---|
| 2010 Lexus HS250h w/SAB | – | – | – | – |
Fuel economy
EPA ratings for each 2010 Lexus HS version.
| Version | City MPG | Highway MPG | Combined | Yearly fuel cost |
|---|
| HS 250h 2.4 L Automatic (variable gear ratios) | 35 | 34 | 35 | $1,900 |
Need this data in your app?
Recalls, complaints, crash ratings and fuel economy as a JSON API. Decode up to 50 VINs per call and get a daily feed of new recalls.
Explore the API →Sources: NHTSA recalls, complaints and 5-Star Safety Ratings, US EPA fuel economy and Transport
Canada's Vehicle Recalls Database (contains information licensed under the Open Government Licence – Canada).
Recalls updated 2026-10-30.