Recalls are issued for a make, model and model year. Whether the repair has already been done on one specific car is known only to its manufacturer and dealers. Check your vehicle's official status at nhtsa.gov/recalls or with a dealer.
No US recalls found for the 2016 Mercedes-Benz GLE-Class.
Show 12 Canadian recalls
Fuel system
2022-12-22 · campaign 2022-741
Issue:
On certain vehicles, water could leak into the rear of the vehicle and build up in the spare tire wheel well. If this happens, the fuel pump control unit could short circuit and cause the engine to stall.
Note: This problem could cause a check engine light to turn on, a damp carpet in the cargo area and/or the sound of water moving in the spare wheel well while driving.
Safety Risk:
A sudden loss of power to the wheels could increase the risk of a crash.
Corrective Actions:
Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealership to inspect for water leaks and install a drain plug in the spare wheel well. The fuel pump control unit will be replaced, if necessary. To reduce the safety risk, you should regularly check for moisture in the cargo area and spare wheel well.
Steering
2018-12-20 · campaign 2018-724
On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), the bolts that attach the electric power steering assist motor to the steering gear housing may corrode and break. This could cause a loss of power steering assist. The resulting increase in steering effort could create the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the mounting bolts and apply a corrosion protection coating to the gear housing and bolts. If the bolts bolt cannot be removed, a replacement steering gear will be installed.
Engine
2018-04-27 · campaign 2018-217
On certain vehicles equipped with the Active Curve System (ACS), the oil in the ACS’s reservoir could start foaming under certain dynamic driving situations in combination with an oil level below minimum. The oil foam could leak out of the oil reservoir through the vent holes in the sealing cap and spray onto hot surface components of the exhaust system. This could increase the risk of fire causing injury and/or damage to property. Correction: Dealers will inspect the ACS reservoir for proper oil level and replace the sealing cap with an updated part.
Structure
2017-10-17 · campaign 2017-501 · 472 vehicles
Certain vehicles may fail to comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts and CMVSS 115 - Vehicle Identification Number (VIN). Excess bulkhead insulation material may have been used during manufacturing, and as a result, could extend into the lower area of the windshield. This excess insulation could cover the VIN label, and potentially affect bonding of the windshield. If the windshield bonding is affected on the passenger side, in the event of a crash (where passenger frontal airbag deployment is warranted), the airbag may not deploy as designed, which would fail to meet the requirements of the standard, and increase the risk of injury in a crash. Correction: Dealers will inspect the bulkhead insulation for excess material and remove it as necessary. In the event of compromised windshield bonding, the bonding will be reworked.
Engine
2017-08-15 · campaign 2017-395
On certain vehicles, the engine control unit may be out of specification. This could result in the engine shutting down when applying the brakes just before stopping the vehicle, and/or with a high engine load combined with an insufficient accelerator pedal actuation following an ECO start. Depending on traffic conditions, an unintentional engine shut-down could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update the engine and transmission control unit software.
Steering
2017-04-11 · campaign 2017-207
On certain vehicles, the electric power steering connector may not be properly sealed against water entry. This could allow moisture to enter the power steering control unit which could interrupt the signal and cause the electric steering assist to deactivate. A loss of power steering assist could unexpectedly increase steering effort which would increase the risk of a crash causing injury and/or damage to property. Correction dealers will replace the connector and, if necessary, replace the steering rack.
Steering
2017-02-09 · campaign 2017-059 · 8 vehicles
On certain vehicles, the connections between the upper control arms and the axle stubs may not have been tightened properly during assembly. This could affect steering and directional control of the vehicle, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will check the bolt torque connections between the upper control arms and axle stubs and replace the upper control arms if necessary.
Structure
2017-02-09 · campaign 2017-060 · 4 vehicles
Certain vehicles may fail to comply with the requirements of Canada Motor Vehicle Safety Standards (CMVSS) 208 - Occupant Protection in Frontal Impacts and CMVSS 212 - Windshield Mounting. The bonding of the windshield might not meet specifications of the 212 standard. This could result in the possibility of the windshield separating in the event of a crash, and in the case of a head-on collision warranting deployment of the passenger frontal airbag, the windshield might not be able to support the airbag as intended, affecting compliance to the 208 standard and increasing the risk of injury to the front passenger seat occupant. Correction: Dealers will replace the windshield.
Seats and restraints
2016-12-13 · campaign 2016-618
On certain vehicles, the calibration of the front passenger seat Occupant Classification System (OCS) may not detect a small statured seat occupant if the occupant is sitting on the edge of the seat and remains stationary for a long period of time. As a result, the passenger frontal airbag may not deploy in a crash, increasing the risk of injury. Correction: Dealers will update the software of the Occupant Classification System.
Lights and instruments
2016-10-18 · campaign 2016-510 · 37 vehicles
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective Devices. The low-beam headlamps may not have been adjusted according to specification, which may deviate from the tolerance range required by the standard. This could reduce vehicle visibility, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will check the setting of the headlamps and correct them as necessary.
Engine
2016-10-18 · campaign 2016-512 · 50 vehicles
On certain vehicles, the engine control unit software may be incorrect. This would result in reduced engine performance of 300kW (600Nm) instead of the specified 320kW (700Nm) listed within vehicle certification documents. Correction: Dealers will replace the engine control unit.
Engine
2016-06-14 · campaign 2016-300 · 714 vehicles
On certain AMG model vehicles, there could be an issue within the software of the engine control unit (ECU) which could cause an engine shut-down just before a vehicle stop. If this were to occur, the driver might mistakenly interpret the engine shut-down as a planned shut-down as part of the ECO start/stop system. However, the engine will not restart automatically after releasing the brake pedal, and would needed to be restarted manually. Depending on traffic conditions and the driver’s reactions, an unintentional engine shut-down could increase the risk of a crash. Correction: Dealers will update the ECU software.
Owners filed 4 complaints with NHTSA about the 2016 Mercedes-Benz GLE-Class. Among 5 model years of this model, it ranks #1 for the most complaints (median 1).
NHTSA 5-Star Safety Ratings for the 2016 Mercedes-Benz GLE-Class.
EPA ratings for each 2016 Mercedes-Benz GLE-Class version.