Recalls are issued for a make, model and model year. Whether the repair has already been done on one specific car is known only to its manufacturer and dealers. Check your vehicle's official status at nhtsa.gov/recalls or with a dealer.
No US recalls found for the 2007 Mercedes-Benz ML-Class.
Show 5 Canadian recalls
Brakes
2022-05-06 · campaign 2022-237
Issue:
On certain vehicles, corrosion could cause the brake booster to fail. If this happens, there may be an increase in brake pedal effort and increase the distance needed to stop the vehicle. In rare cases of severe corrosion, the brake booster could separate completely and cause a loss of brakes.
Safety Risk:
A loss of brakes can increase the risk of a crash.
Corrective Actions:
Mercedes-Benz advises you to stop driving your vehicle immediately. The company will notify owners by mail and instruct you to contact a local Mercedes-Benz dealership to arrange for towing and an inspection. The dealer will remove the rubber brake booster sleeve and determine whether the vehicle is safe to drive or if it can't be driven and a parts replacement is necessary. Also, depending on the results of the inspection, you may need to return within two years for a re-inspection.
Other
2008-07-09 · campaign 2008-242 · 33 vehicles
Certain vehicles may have been programmed with incorrect software calibration data during the manufacturing process. This could affect various functions such as: The electric fuel pump may not receive a signal which, in case of a crash, may prevent the fuel pump from disconnecting as designed; The maximum speed limiter may not be activated; The fuel gauge readings may be incorrect; A stuck fuel-level sensor may not be displayed in the instrument cluster; The speedometer may be out of tolerance which, as a result, may indicate inaccurate vehicle speed; The On-Board Diagnostic (OBD) system may reduce the emission level applicable to the vehicle, causing the Check Engine Light to illuminate incorrectly. Correction: Dealers will reprogram the electronic control module.
Other
2008-06-02 · campaign 2008-191
On certain vehicles, trailer hitches, whether installed during vehicle assembly, or sold as an over-the-counter accessory and installed by the dealer, may contain inadequate welds and, as a result, could eventually fail. This could allow the towed unit to separate from the towing vehicle, causing property damage, personal injury or death. Correction: Dealers will repair weld the hitch assembly.
Engine
2007-12-21 · campaign 2007-418
On certain diesel powered E320, GL320, ML320 and R320 vehicles, the crankshaft sensor may fail, causing the engine to stall. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Correction: Dealers will replace the crankshaft sensor.
Other
2006-12-27 · campaign 2006-372 · 49 vehicles
On certain vehicles, the accelerator pedal might not have been fully fastened to its mounting studs during vehicle assembly. Due to the geometry and tension in the assembly, the mounting studs will maintain the position of the accelerator pedal but may, over time, not maintain a consistent pedal position, which could make it more difficult to operate the accelerator. Correction: Dealers will inspect the pedal assembly and, if required, install two nuts.
Owners filed 1 complaints with NHTSA about the 2007 Mercedes-Benz ML-Class. Among 3 model years of this model, it ranks #3 for the most complaints (median 2).
NHTSA 5-Star Safety Ratings for the 2007 Mercedes-Benz ML-Class.
EPA ratings for each 2007 Mercedes-Benz ML-Class version.